Including utilities in the rent is two decisions at once: what your listing says this month, and what you are tied to for the length of the tenancy. One number with heat, hydro and water inside it is easier to advertise and far harder to walk back. A lower number plus utilities caps what you carry and makes your listing harder for a renter to compare. Four criteria settle it, and most landlords check the reversible one last.
The two options, one line each
Inclusive rent: you hold the accounts, you pay the bills, the tenant pays one figure that does not move when the weather does. Rent plus utilities: the tenant opens the accounts in their own name, pays the utility directly, and your rent covers the building alone.
Criterion 1: including is close to permanent
This is the criterion that decides it. Once you supply a utility, tenancy law treats it as part of what the tenant is paying for.
In British Columbia, the Residential Tenancy Act defines a service or facility to include utilities and related services and heating facilities or services. Section 27 then says a landlord must not terminate or restrict a service or facility that is essential to the tenant's use of the unit as living accommodation, or where providing it is a material term of the agreement. Heat in a BC winter is a hard argument to lose. For anything outside that bar, you need 30 days written notice in the approved form and a rent reduction equal to the drop in value of the agreement.
Ontario's Residential Tenancies Act lists heating facilities and services and utilities and related services in its definition of services and facilities. Under section 130, a tenant can apply to the Landlord and Tenant Board for a rent reduction because a service was reduced or discontinued, and a former tenant can apply for a period they were affected while still a tenant. Electricity has its own section: once a meter or suite meter is in place, section 137 lets you end your obligation to supply it only with the tenant's written consent on a Board-approved form, adequate notice, and a rent reduction set by regulation that accounts for the cost of consumption. Where the primary heat source in the unit is electric, that route narrows to prescribed circumstances only.
Alberta sits at the other end. The province's Residential Tenancies Act never uses the word utilities and has no service-reduction mechanism, so your lease governs, and the only unilateral change it gives you on a monthly tenancy is a rent increase on three tenancy months notice.
Read all three the same way. Excluding utilities is a decision you revisit at the next vacancy. Including them is one you may live with until the tenant leaves, for the same reason a parking stall you provide sits inside the rent.
Criterion 2: whether the unit can be split at all
Check the meters before you check the market. A basement suite on the house panel, or a duplex on a single gas line, cannot be handed over by phoning the utility. Plus utilities then means apportioning a shared bill, and that is its own regime.
In Ontario, section 138 covers a building with no more than six rental units where the landlord supplies a utility to each one. You can charge a tenant a share of the cost, but only with written consent, adequate notice and a rent reduction. Three consequences come with it. The apportioned utility stops being a service inside the definition of rent. You cannot serve a notice of termination or apply to the Board over an unpaid utility share. And before signing a new tenant you have to disclose the percentage applicable to that unit, the building's total utility cost for the prescribed period, and which parts of the building sat vacant during it.
Apportioning turns your utility history into a disclosure, vacancies included.
Criterion 3: who carries a cold winter
An inclusive rent moves by the guideline in a rent-controlled province. Your gas bill does not. Over a four-year tenancy you are betting that capped increases keep pace with uncapped energy costs, and the tenant at the thermostat has no reason to turn it down.
Excluding utilities removes that exposure and adds a smaller one. A tenant paying their own heat in a poorly insulated unit may underheat it, and condensation, mould and frozen pipes cost more than the gas would have. In a draughty unit, the inclusion is partly insurance against your own building envelope.
Either way, the empty months are yours. The account reverts to the owner between tenants under both models, which is its own piece of work to keep the utilities on between tenants.
Criterion 4: what the number does to your enquiries
An inclusive rent prices above the comparable listings for the same unit type, and a renter scanning a portal sees the higher number before they see what is in it. Put the inclusion in the headline and the first line of the description, not only in a features list, or the premium reads as an overpriced unit.
Plus utilities has the opposite problem. The number looks competitive and the first enquiry asks what heat runs. Have a real range from the last 12 months of bills ready. A guess that comes in low becomes a complaint in February.
If you include, price it from the bills
- Pull 12 consecutive months of actual bills for that unit, not an average month and not a quote.
- Add the 12 together and divide by 12, so the winter peak is carried by every month of the year.
- Add a margin for a colder year and for rate increases across the whole term, because you cannot adjust this mid-tenancy.
- In a rent-controlled province, test the figure against four years of guideline increases rather than one.
- Write the inclusion into the lease by name. Heat, hydro, water and hot water are four separate things, and silence gets read against the landlord.
The short version
Include when the unit cannot be metered on its own, when it is small and efficient, or when the comparable listings all include heat and yours would look odd without it. Exclude when the unit has its own meters, when heating costs are large or volatile, or when you expect a long tenancy under a rent cap. Undecided on a separately metered unit? Exclude. That is the choice you can change at the next turnover, and the one you cannot change is not worth a slightly better listing.
